Storm Response

How to Prepare Your Trees for Pacific Northwest Windstorm Season

A pre-storm checklist for Portland metro homeowners: which trees to look at, what pruning actually helps, and why the work should be done before November.

James Cowell, Owner 5 min read
Arborist pruning deadwood from a tall Douglas fir beside a Portland-area home ahead of windstorm season
// Storm ResponseNorth Woods Tree Service
THE SHORT ANSWER

To prepare trees for Pacific Northwest windstorm season, inspect trees within striking distance of your home, remove dead and broken limbs, and have an ISA Certified Arborist thin or reduce crowns to standards (never topping). Consider cabling for split trunks, clear branches from roofs, and remove trees with serious defects. In the Portland metro, schedule this work before November storms arrive.

KEY TAKEAWAYS
  • Start with trees that could reach the house, garage, driveway, or play areas if they fell.
  • East wind events and saturated winter soils are the main reasons healthy-looking Oregon trees fail.
  • Crown thinning and reduction to ANSI A300 standards lower wind load; topping makes trees more dangerous.
  • Deadwood removal and roof clearance are the fastest, most affordable storm prep wins.
  • Trees touching primary power lines are the utility's job; report them instead of cutting.
  • Book storm prep in late summer or early fall so it is done before November.

Which trees should you check before windstorm season?

Start with every tree that could hit something important if it fell. A simple rule is to look at any tree whose height is greater than its distance to your house, garage, shop, driveway, or the spot where your kids play. Those are the trees that deserve a closer look this fall.

Walk around each one and look for dead branches in the canopy, cracks or splits in the trunk, mushrooms or conks at the base, soil heaving on one side, and a new or worsening lean. Tall Douglas fir and western red cedar along property lines, and bigleaf maple with multiple trunks, are common trouble spots in Clackamas County storms.

If you spot any of these defects, our guide to the warning signs a tree is becoming dangerous walks through what each one means. Douglas fir with thinning crowns may also be dealing with laminated root rot, which weakens roots long before the canopy shows it.

Why do east wind events and wet soil topple Oregon trees?

Most of our trees grew up bracing against southwest winds, so a strong east wind pushes them in a direction their roots and wood are not built for. East wind events coming out of the Columbia River Gorge can hit Portland, Gresham, and the east side of Clackamas County hard, and trees that survived decades of normal storms can fail in a single night.

Saturated soil makes it worse. After weeks of fall rain, the ground loses its grip on roots, and a big conifer with a full crown acts like a sail. That is why whole trees uproot in Oregon instead of just losing limbs. Ice storms add weight on top of that, especially on broadleaf trees and on conifer limbs already loaded with water.

You cannot control the weather, but you can control how much sail your trees carry and whether weak trees are standing near the house when the first big storm arrives.

Does pruning really help trees survive wind?

Yes, the right pruning reduces how much a tree catches the wind and removes the weakest parts before they fail. The two cuts that matter most are crown thinning, which selectively removes some interior branches so wind passes through, and crown reduction, which shortens the longest limbs back to healthy lateral branches to lower the load on the trunk.

Both should be done to ANSI A300 pruning standards, the industry standard ISA Certified Arborists follow. Over-thinning can actually make a tree less stable, so the goal is a measured cut, not a dramatic one.

Never top a tree. Topping cuts the main stems to stubs, which triggers a burst of weakly attached sprouts that break easily in the next storm, and the stubs often decay. Our post on why tree topping hurts your trees covers what to do instead. For storm-focused pruning, see our tree trimming and pruning service.

Why is deadwood removal the first priority?

Dead branches are the first things to fall in a windstorm, and they often fall in calm weather too. Removing deadwood is one of the simplest ways to cut storm risk, and it can be done any time of year.

Large dead limbs in tall conifers, sometimes called widowmakers, can come down through roofs, cars, and fences. Removing them often requires climbing or a lift, so it is not a DIY job. Have the crew also clear broken hangers left over from last winter's storms, which can sit loose in a canopy for months.

From the ground, dead limbs are easiest to spot in late summer, when they stand out as bare or brown against green foliage. Binoculars help with tall firs. Make a quick list or take photos of what you see, and share it when you request an estimate so the crew can plan climbing or lift access.

Deadwood work pairs well with a general crown cleaning, which also removes crossing, rubbing, and broken branches. On large trees near the house, that single visit often handles most of the storm risk you can see.

When does cabling or bracing make sense?

Cabling can help a valuable tree with a structural weakness, such as a codominant trunk with a tight V-shaped union, stay together in high winds. A flexible steel cable installed high in the canopy limits how far the stems can move apart.

Cabling is a supplement, not a fix for a failing tree. It does not help a tree with root rot, a large cavity at the base, or a severe lean, and cables need periodic inspection. An ISA Certified Arborist can tell you whether a tree is a good candidate or whether removal is the safer choice.

Cabling is usually paired with pruning that reduces weight on the stems being supported. In some cases a rigid steel rod, called bracing, is installed lower in the tree through a split or weak union. Both should be installed to ANSI A300 standards, and both should be checked every few years, especially after a major storm.

How much clearance should trees have from your roof and power lines?

Keep branches off the roof and away from siding, chimneys, and gutters. Limbs that rub the roof wear down shingles, and in a storm they act like levers against the structure. Pruning back to give the house some breathing room also helps the roof dry out in our wet winters.

Power lines are different. Trees touching the primary lines on the poles along the street are handled by the utility, such as PGE, or its line-clearance contractors. Report those trees to the utility rather than cutting them yourself or hiring someone to do it. Branches near the service drop that runs to your house can usually be managed by a qualified tree crew, sometimes with the utility temporarily disconnecting the line.

Before any digging for planting or stump work, call the Oregon Utility Notification Center at 811 to locate buried lines.

When is removal the right call, and when should the work be done?

Remove a tree before storm season when it has major structural defects, active root rot, a sudden lean, or significant dead canopy, and it is close enough to hit something important. Taking a hazard tree down on a calm day is safer, cleaner, and easier to schedule than an emergency removal off a roof. Many cities regulate removals, so check our tree permit guide first. North Woods helps you identify what your job requires, and the property owner submits any permit.

Timing matters. The best window for storm prep is late summer through October, before the November storms and before crews are tied up with emergency calls. Book early, especially for tree removal or large pruning jobs.

North Woods works across Clackamas County, Multnomah County, and Washington County, including Gresham and Lake Oswego. If a tree near your house has you worried, call (503) 656-5802 for a free estimate with no deposit, and an arborist will tell you what it needs before the wind does.

JC
ABOUT THE AUTHOR

James Cowell owns and runs North Woods Tree Service, the family business founded by Daryl North in Beavercreek, Oregon in 1986. North Woods handles tree removal, pruning, storm response, land clearing, and logging across Clackamas, Multnomah, and Washington Counties, with an ISA Certified Arborist on staff and 200+ customer reviews across Google, Angi, Facebook, Yelp and Housecall Pro.

FREQUENTLY ASKED

Questions about this topic

Direct answers for homeowners, builders, and property managers across the Portland metro.

Late summer through October is the best window in the Portland metro. It gives you time to finish before November storms and before tree crews fill up with emergency calls. Deadwood removal and hazard work can be done any time, while larger structural pruning on deciduous trees is often scheduled for the dormant season.

Proper crown thinning lets wind pass through the canopy and removes weak branches, which can reduce storm damage. It must be done to ANSI A300 standards by a trained arborist. Over-thinning, or stripping all the inner branches, leaves weight at the tips and can make a tree less stable, so more is not better.

No. Topping cuts main stems to stubs, which causes fast-growing, weakly attached sprouts and decay at the cuts. Within a few years the tree is often more dangerous than before. Crown reduction to healthy lateral branches lowers height and wind load without the damage. North Woods never tops trees.

Trees near primary lines on utility poles are maintained by the utility, such as PGE, or its line-clearance contractors. Report concerns to your utility. Branches near the service line that runs to your home can usually be handled by a qualified tree service, sometimes with the utility temporarily disconnecting power for safety.

East winds push trees in a direction they are not adapted to, since Oregon trees grow braced against prevailing southwest winds. When east wind events arrive after heavy fall rain, saturated soils loosen root grip, and large conifers with full crowns can uproot entirely. Tall trees near open areas are most exposed.

Cabling can help a healthy tree with a weak V-shaped union or codominant stems by limiting how far they move in wind. It is not a fix for decay, root rot, or a large crack that is already opening. An ISA Certified Arborist should inspect the tree and tell you whether cabling or removal is the safer choice.

Consider removal when a tree near structures has significant dead canopy, a new or worsening lean, fungal growth at the base, a large cavity, or signs of root rot. North Woods offers free estimates with an ISA Certified Arborist on staff who can assess the risk and explain whether pruning or removal makes more sense.

Licensed · bonded · insured · local
Family-owned since 1986
Oregon CCB #209975
Licensed, bonded & insured
ISA Certified Arborist on staff
200+ reviews across 5 sites
BBB Accredited
Free estimates · $0 deposit
Open 7 days · 7am–7pm
Family-owned since 1986
Oregon CCB #209975
Licensed, bonded & insured
ISA Certified Arborist on staff
200+ reviews across 5 sites
BBB Accredited
Free estimates · $0 deposit
Open 7 days · 7am–7pm
NEXT STEP

Ready for a free, no-pressure estimate?

Tell us about your trees or your site. We'll take a look and send a written estimate with $0 deposit. Cleanup is included on most jobs.